3D-Drucker

Firmware Update

https://github.com/NARUTOfzr/Neptune_3_Pro_Plus_Max/blob/main/README-en.md

Einstellung der E-Steps (Extruder Schritte)

Installation des Druckertreiber

Download und Start von Pronterface

Verbinden

M503 senden -> Einstellungen

SENDING:M503
echo:; Linear Units:
echo:  G21 ; (mm)
echo:; Temperature Units:
echo:  M149 C ; Units in Celsius
echo:; Filament settings (Disabled):
echo:  M200 S0 D1.75
echo:; Steps per unit:
echo:  M92 X80.00 Y80.00 Z400.00 E390.00
echo:; Max feedrates (units/s):
echo:  M203 X300.00 Y300.00 Z5.00 E25.00
echo:; Max Acceleration (units/s2):
echo:  M201 X700.00 Y700.00 Z100.00 E1000.00
echo:; Acceleration (units/s2) (P<print-accel> R<retract-accel> T<travel-accel>):
echo:  M204 P3000.00 R3000.00 T3000.00
echo:; Advanced (B<min_segment_time_us> S<min_feedrate> T<min_travel_feedrate> X<max_jerk> Y<max_jerk> Z<max_jerk> E<max_jerk>):
echo:  M205 B20000.00 S0.00 T0.00 X10.00 Y10.00 Z0.40 E5.00
echo:; Home offset:
echo:  M206 X0.00 Y0.00 Z0.00
echo:; Auto Bed Leveling:
echo:  M420 S0 Z2.00 ; Leveling OFF
echo:; Material heatup parameters:
echo:  M145 S0 H200.00 B50.00 F0
echo:  M145 S1 H240.00 B80.00 F0
echo:  M145 S2 H220.00 B60.00 F0
echo:  M145 S3 H200.00 B50.00 F0
echo:; Hotend PID:
echo:  M301 P22.20 I1.80 D119.00
echo:; Power-loss recovery:
echo:  M413 S1 ; ON
echo:; Z-Probe Offset:
echo:  M851 X-28.50 Y22.00 Z0.00 ; (mm)
echo:; Skew Factor:
echo:  M852 I0.000000 J0.000000 K0.000000 ; XY, XZ, YZ
echo:; Filament load/unload:
echo:  M603 L0.00 U100.00 ; (mm)

...

M92 E410.52
M500

...

Neuer Wert:

echo:  M92 X80.00 Y80.00 Z400.00 E410.52

https://www.youtube.com/watch?v=uwWITeWgTQM

Z-Offset

10:19